The guy wires are attached to the upper half of each mast section with a guy ring and clamp. This will give the extra strength required for most installations. Telescoping masts generally require 4 guy wires for each 10 foot section. Standard antenna masts (10 feet in height) require only one set of three guy wires. Six-strand 18 or 20 gauge galvanized steel guy wire is recommended for general use(The 18 gauge wire is recommended for high-wind areas and installations over 20 ft. The materials needed for a standard guy wire installation are: guy wires, guy ring(s), screw eye, and turnbuckles. However, only the best quality materials and careful installation will provide sturdy, safe, long-lasting support.
The correct installation procedure is relatively simple. Consistent, safe support of antenna installations over 10 feet above the uppermost wall bracket or roof mount depend on how well the guy wires are installed.